How to set up and maintain a fully automatic potato watering system in the rust farming 2.0 update.
Guide To Automatic Potato Watering System
Instructions
This guide is here to show you the basics of setting up a timer with a automatic on and off sequence.
For this setup you will need:
- 1 - fluid pump.
- 2 - blockers.
- 3 - timers.
- 9 - electrical branches.
- 1 - wire tool.
With the picture above using your wire tool, connect the electrical component to its matching color on another electrical component.
Once you have all the wires set up all you need is power (hook up a medium or large battery to a switch and then run the output of that switch into the input of the bottom left-most electrical branch ) then all you need to do is set up the correct power settings on your electrical branches and correct times for your timers (as shown with the white numbers on the timers and electrical branches accordingly) then all you need to do is hook water up to your pump.the power output on the bottom left electrical branch, the same one you plugged your switch into (the power output is the one on the top left of the electrical branch) is then plugged into the lights of your farm and the water is put into the sprinklers. and then all you need to do is turn it on and your done! (depending on the area you have your farm in you might need to adjust the timer on the top left to have more or less time in between watering sessions).
Source: https://gameplay.tips/guides/7477-rust.html
More Rust guilds
- All Guilds
- Rust - Best Binds List (Survival and PvP)
- Rust - Raid Cost Sheets Guide (2020)
- Rust - Beginners Tips
- Rust - How to Do Oilrig So Fast
- Rust - Cost of Raiding (Melee Weapons)
- Rust - Recycler Guide
- Rust - Complete Achievements Guide (Sunburn DLC)
- Rust - Twitch Drops Guide (January 2021)
- Rust - Guide to Farming, Tea and Buffs